How do I remove the control panel to replace the low voltage wiring harness?

Tubs made prior to 2006 had just had a sticky adhesive gasket holding it down to the tub surface. Apply gentle heat to the topside then pry off the tub surface with a flat head screw driver. Tubs made 2006 and after will have a # 1 Philips head at each end of the topside and the sticky adhesive gasket. Peel the graphic overlay up to reveal the screws, remove them and then apply heat and pry off. The cable is attached to the backside of the topside so you will need to unplug it from the management system.